1 example of patrol sequence programming, 23 switching on and switching off, 24 dip switch sw6 and sw4 configuration table – Videotec EXDTRX User Manual
Page 20
EN - English - I
nstruc
tions manual
18
6.2.24 Dip switch SW6 and SW4
configuration table
SW6
Dip
Position
Function
1
ON
PELCO D protocol
1
OFF
VIDEOTEC or MACRO
protocols (setting the dip 8
of SW4)
2, 3, 4
Indifferent
No function
SW4
Dip
Position
Function
1, 2
OFF, OFF
9600 baud* (VIDEOTEC and
MACRO), 2400 PELCO D
1, 2
ON, OFF
300 baud VIDEOTEC, 38400
baud MACRO, 4800 baud
PELCO D
1, 2
OFF, ON
1200 baud (VIDEOTEC and
MACRO), 9600 baud PELCO D
1, 2
ON, ON
19200 baud (VIDEOTEC,
MACRO and PELCO D)
3
OFF
Unused alarms*
3
ON
Used alarms
4
OFF
N.C. alarms*
4
ON
N.O. alarms
5
OFF
-
5
ON
Alarms on Aux4
6
OFF
-
6
ON
To release Aux3 and Aux4
7
OFF
-
8
ON**
VIDEOTEC standard
protocol****
8
OFF***
MACRO protocol **** ((DCIR,
DCJ, DCT and DCTEL)
Tab. 04 * Default settings.
** Compatible with keyboards DCIR, DCJ, DCT and
DCTEL with VIDEOTEC standard protocol.
*** Compatible with keyboards DCIR, DCJ, DCT and
DCTEL with MACRO protocol.
**** Selectable only if the dip 1 of SW6 is in OFF
position.
6.2.22.1 Example of Patrol sequence
programming.
If you want to set up a Patrol sequence that starts
from Preset position 19, ends at Preset position 33
and stops for one minute at every position reached:
: Enables parameter insertion;
: Start Patrol at position 19;
: End Patrol at position 33;
: Pause of 60 seconds at every position
reached;
: Start of sequence;
: End of sequence.
6.2.23 Switching on and switching off
Before connecting the unit:
• Make sure that the goods supplied correspond
to the required specifications by controlling the
rating plates ("4.2 Product markings", page 7);
• Make sure that the fuses of the EXDTRX3 /
EXDTRX324 receiver are not damaged;
• Make sure that the receiver and the other
components of the plant are closed in order to
avoid the direct contact with live elements;
• Make sure that all parts are accurately and firmly
fixed;
• The power cords must not hamper the normal
operations of the installer and the movement of
the positioning device;
• Make sure that all power sources and the
connecting cables are able to bear the system
consumption.