ARI Armaturen ARI-PREMIO Plus EN - Manual (Page 42)

Page 42 0040501004 5010
Operating and installation instructions
Thrust actuator ARI-PREMIO-Plus
7.0 Care and maintenance
The thrust actuator requires very little maintenance. Accordingly maintenance in specified
intervals is not necessary.
Remove any externally visible dirt from the actuator and the electronics occasionally,
depending on the operating conditions.
No liquid must be allowed to come into contact with or get inside the electronics!
Never clean the actuator using liquids or aggressive solvents or agents that are detrimental
to health or highly flammable.
We recommend dampening a cloth with cleaning agent to clean the actuator rather than
applying it directly.
8.0 Troubleshooting
In the event of malfunction or faulty operating performance check that the installation and
adjustment work has been carried out and completed in accordance with these Operating
Instructions.
If malfunctions cannot be eliminate with the help of the following table
“9.0 Troubleshooting table”, the supplier or manufacturer should be consulted.
NOTE !
The power supply cable must be disconnected from the mains (i.e. de-
energised) prior to cleaning the electronics. Suitable precautions must be
taken to prevent the mains voltage from being re-connected
inadvertently.
Non-observance can result in death, severe personal injury or substantial
property damage.
-
ATTENTION !
- It is essential that the safety regulations are observed when identifying faults.