ARI Armaturen ARI-PREMIO Plus EN - Manual (Page 35)

0040501004 5010 Page 35
Operating and installation instructions
Thrust actuator ARI-PREMIO-Plus
5.7.1.5 Operation – Programming / clearing positions
Fig. 20
Programming Procedure
Relay 1
- Approach the spindle position.
- Press "Relay 1 button (up)" until the corresponding LED blinks
once.
- From now on, relay 1 is switched to "active" when the current
position is overtravelled in the UP direction.
Relay 2
- Approach the spindle position.
- Press "Relay 2 button (down)" until the corresponding LED blinks
once.
- From now on, relay 2 is switched to "active" when the current
position is overtravelled in the DOWN direction.
Clear
- Press "Relay 1 button (up)" AND "Relay 2 button (down)"
simultaneously for longer than one second.
- Both LEDs blink once to confirm the new setting.
- From now on, the two relays are no longer switched.
Overwrite
Similar to Prog. Rel.1 or Prog. Rel.2.
The new position automatically overwrites the old position.
Test
Move the spindle to and fro with any type of control (e.g. MAN
switch) and watch the LEDs.
"Relay 1" LED (up)
"Relay 1" button (up)
"Relay 2" button (down)
"Relay 2" LED (down)