ARI Armaturen ARI-PREMIO Plus EN - Manual (Page 26)

Page 26 0040501004 5010
Operating and installation instructions
Thrust actuator ARI-PREMIO-Plus
5.5 Settings - Handling
5.5.1 Display and operating elements of the standard electronics
Fig. 14
ATTENTION !
- The thrust actuator may only be operated for a short time without the hood for
unavoidable setting operations to the electronics, the relay board and the
electrical options. While these operations are in progress, the thrust actuator
has hazardous, live, uninsulated parts exposed as well as moving and rotating
parts.
- Improper execution of the setting operations or lack of care may cause death,
grievous bodily injury or substantial property damage.
- Operation of the thrust actuator without the hood for any purpose other than
that described above is strictly prohibited.
LEDs for status information
Sensitivity setting for the diagnostic
signal
0 = Off to 3 = Sensitive
Local operation of the actuator
- Up, stop, down
- Auto: The actuator follows the control
signals
LEDs for travel in open / close
direction
Reset button or start / cancel
initialisation run
Configuration of the analogue control
signal
- Current / voltage
- Inversion
- Characteristic correction
Actuator functions
- Force off
- Anti-block retraction program
- Economy – wear reduction program