Vaisala WMT700 - Manual (Page 65)

Chapter 4 ________________________________________________________________ Installation
When unpacking the wind sensor, remove the transportation
damper that protects the sensor body. To avoid bending or
twisting the array, do not remove the damper protecting the array
until you have installed WMT700. Figure 23 below shows the
damper protecting the array.
Retain all original packaging in case you have to return WMT700
to Vaisala Service Center for maintenance purposes. You can
uninstall WMT700 by performing the steps of the mounting
procedure in reverse order.
1005-025
Figure 23 WMT700 and Transportation Damper
Mounting
You can mount WMT700 either on a vertical pole mast or a
horizontal cross arm. Each of the mounting options is further
described in the following sections.
For information on the dimensions of WMT700, see Dimensions
on page 193.
VAISALA ________________________________________________________________________ 63