Vaisala WMT700 - Manual (Page 50)

User's Guide ______________________________________________________________________
Figure 16 below shows the configuration and measurement modes
of both serial ports provided by WMT700.
1001-111
Figure 16 Configuration and Measurement Modes
After power-up, WMT700 is in the measurement mode. To
change settings, use the OPEN command to enter the
configuration mode. When you have changed the settings, use the
CLOSE command to exit the configuration mode. WMT700
serial ports also exit the configuration mode automatically if they
do not receive commands within 2 minutes.
For information on the OPEN and CLOSE commands, see
section Entering and Exiting Configuration Mode on page 109.
48 ___________________________________________________________________ M211095EN-E