Vaisala WMT700 - Manual (Page 165)

Chapter 5 _________________________________________________________________ Operation
WS425 A/B WAT11 Profile
Configurable Parameters
Table 52 below lists the configurable parameters and their
allowed and default values for the WS425 A/B WAT11 profile.
Table 52 Configurable Parameters for WS425 A/B
WAT11 Profile
Parameter Default Value Profile-Specific Allowed
Values Description
com1_protocol 0* 6 = WS425 A/B WAT11 Profile for serial port COM1
com2_protocol 0 6 = WS425 A/B WAT11 Profile for serial port COM2
* The parameter has no protocol-specific default value. It is determined
separately in the configuration code.
To start continuous measurement, use the START command.
You can stop the measurement with the STOP command. For
instructions, refer to sections START — Start Continuous
Measurement and STOP — Stop Wind Measurement on page
115.
WS425 A/B WAT11 Commands
When the WS425 A/B WAT11 profile is selected, you can poll
data using the following command:
where
= Escape character ASCII 27H
= WMT700 ID, for example, A
VAISALA _______________________________________________________________________ 163