Vaisala WMT700 - Manual (Page 119)

Chapter 5 _________________________________________________________________ Operation
CLEARERR — Reset Error Codes
and Counts
This command resets the error counters of WMT700.
CLEARERR
POLL — Get Message
This command fetches the latest measurement data from
WMT700. You need to specify the data message format in the
command.
NOTE Vaisala recommends that you only use this command for testing data
connections. To fetch measurement data for other purposes, switch the
serial port to the measurement mode. The polling command in the
measurement mode depends on the selected profile.
POLL y
where
y = Identification number for the data message format. For a list
of data message formats, see Table 40 on page 128
RESET — Reset CPU
This command resets WMT700.
RESET
Information Commands
? — Display Command Set
This command displays a list of available configuration
commands.
?
H — Display Help and Messages
This command displays a list of supported data messages and
their identification numbers as well as the available values for
VAISALA _______________________________________________________________________ 117