Vaisala WMT700 - Manual (Page 137)

Chapter 5 _________________________________________________________________ Operation
Measurement Mode Commands
The available commands in the measurement mode depend on the
selected profile.
NOTE For a list of serial commands available for all the communication profiles
supported by WMT700, see Appendix A, Complete Command Set for
WMT700, on page 195.
For more detailed information on commands of the WS425 and SDI-12
profiles, see section Operating WMT700 with WS425 and SDI-12
Profiles on page 145.
WMT700 Profile Commands
When the WMT700 profile is selected, you can use the
commands listed in this section to operate WMT700. In each of
the command descriptions below, is an ASCII carriage
return control character and is an ASCII line feed control
character. Commands may be sent at any speed. The command is
executed when end-of-line character is received.
Each measurement mode command must start with the user-
configurable WMT700 address. It can be any string of printable
ASCII characters, with the maximum length of 30 characters.
Characters , , and $ are not allowed. If you use 0 as
the address in the command, WMT700 responds regardless of the
configured address.
If response for parameter setting is enabled (messages parameter
is set to 1), WMT700 responds to an invalid command with an
error message.
VAISALA _______________________________________________________________________ 135