Vaisala GMP343 - Manual (Page 93)

Appendix B ________________________________________________________ List of Commands
VAISALA_______________________________________________________________________ 91
Calibration Commands
Setting and Testing the Analog Outputs
Advanced Measurement Commands
PARAM Display parameters
TIME Display or set time since reboot
VERS Display the SW version information
CALIB ON Turn on the calibration mode
CALIB OFF Turn off the calibration mode
LC Linear correction mode
LCI Enter linear correction
MPC Multipoint correction mode
MPCI Enter multipoint correction
AMODE Set analog output HW (current or voltage mode)
AHIGH Analog output high concentration value
ALOW Analog output low concentration value
ACUT Analog output over range cut
ILOW Analog output low current value
UHIGH Analog output high voltage value
AERR Change the analog error output value
ATEST Test the analog outputs
LINEAR Set linearization ON/OFF
HEAT Set optics heating ON/OFF
RANGE Set measurement range to optimize performance