Formatting the measurement message, Formatting the message, Table 4 – Vaisala GMP343 User Manual
Page 37: Quantities, Table 5, Modifiers
Chapter 4 ________________________________________________________________ Operation
VAISALA_______________________________________________________________________ 35
Formatting the Measurement Message
Formatting the Message
This command is used to change the serial output format of the commands
SEND and R.
FORM x
SAVE
x= format string
Format string consists of quantities and modifiers. You can select one or
more of the following quantities by keying in the abbreviation after
FORM command:
Table 4
Quantities
Abbreviations Quantities
CO2
Filtered CO
2
results. Factory setting.
CO2RAW
Unfiltered CO
2
results.
CO2RAWUC
Unfiltered CO
2
results. Compensations (P/T/RH/O
2
)
and corrections (MPC/LC) do not apply.
TIME
Time passed from last reset
ADDR
Transmitter address
ERR
Error flag (0=no error/1=error) in POLL or RUN modes.
T
Measured temperature
P
User-set pressure value
RH
User-set relative humidity value
O
User-set oxygen value
Table 5
Modifiers
Abbreviations Explations
x.y
length modifier (whole numbers and decimal places)
#t
tabulator
#r
carriage-return
#n
line feed
""
string constant
U5
unit field and length