Vaisala GMP343 - Manual (Page 62)

User’s Guide ______________________________________________________________________
60 ___________________________________________________________________M210514EN-E
Memory Handling
Reverting the Factory Parameters
Use this command to revert the original factory settings.
>factory
Parameters loaded from Flash.
>
Remember to check the settings after using this command.
Saving the Setting
SAVE
Saves the parameters and settings to EEPROM memory.
Setting the Optics Heating ON/OFF
Enables or disables optics heating.
HEAT
x=ON or OFF (default =ON)
Example:
>heat
HEAT : ON ? off
>
Resetting the Transmitter
RESET
This command resets the device. If the device is in RUN mode, outputting
the results starts immediately after resetting.