Setting the continuous outputting interval, Outputting the reading once, Setting the serial interface measurement mode – Vaisala GMP343 User Manual

Page 34

User’s Guide ______________________________________________________________________

32 ___________________________________________________________________M210514EN-E

Setting the Continuous Outputting
Interval

INTV xxxx yyy

SAVE

xxxx=output interval (1...1000) default=1 s

yyy=unit (s, min or h)

Example: Output interval is changed to 5 seconds

>intv 5 s

INTERVAL : 5

UNIT : S

Outputting the Reading Once

In STOP mode:

SEND

In POLL mode:

SEND aa

aa=address of the transmitter when more than one transmitter is connected
to a serial bus (0...99).

The output mode can be changed with the command FORM.

>send

348.7 ppm

Setting the Serial Interface Measurement
Mode

SMODE xxxx

SAVE

xxxx= STOP/RUN/POLL