EOTech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illuminator Module - Manual (Page 48)

2-22
2.8 USING THE LASERS - Continued
a. Uses an Illuminator Diffuser over the IR Illuminator
identical to that described for the Tri-Function Lens
Cap.
b. Uses a Pattern Generator to project a specific
holographic design over the aim points of both the
Visible and IR Aim Lasers resulting in a 2.6m shape
at 300m (see Figure 2-12). Shapes are visible with
the naked eye if using the Visible Aim Laser and
with night vision devices if using the IR Aim Laser.
Figure 2-12 Pattern Generator Shapes
IR Illuminator Pulse Mode
In addition to momentary and continuous modes of
operation, the IR Illuminator may be programmed to operate
in pulse mode at either 1, 4, or 8 pulses per second.
Programming the IR Illuminator pulse rate is accomplished
as follows:
a. With the Mode Selector turned to the O (OFF)
position, hold down the FIRE Button.
b. Turn the Mode Selector to the desired pulse rate as
shown in Table 2-6. The rate will display on the LED
Status Indicator (the LED will flash green the same
number of times as the Illuminator pulse rate).