EOTech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illuminator Module - Manual (Page 38)

2-12
2.6 ZEROING PROCEDURES
After establishing the factory preset or boresighting the
MIPIM / weapon combination, the MIPIM may be zeroed to
the weapon via live fire at a 25-meter range as described
below. Table 2-4 provides target offsets that must be
applied to the 25-meter zeroing target. Refer to Tables 2-1,
2-2, and 2-3 for adjuster rotation and resultant direction of
shot group movement.
NOTE
The Boresight Adjusters move the aiming beams
at the rate of 0.2 mrad per click. Two clicks = 1
box on a standard 25-meter zeroing target.
NOTE
Direct sunlight may hinder the ability of the user to
effectively see the Visible Aim Laser on the target.
a. On a 25-meter zeroing target, mark the designated
strike point and designated strike zone for the
weapon you are using (see Table 2-4).
b. Mount the target on an “E” silhouette or other
suitable surface at 25 meters.
c. Mount the MIPIM to the weapon.
d. Rotate the Mode Selector to the AL (IR AIM LOW)
position.
e. Activate the IR Aim Laser in continuous mode by
double-tapping the FIRE Button.
f. With the use of a night vision device, direct the IR
Aim Laser at the center of the target.