DiabloSport Trinity T-1000 Comprehensive User Manual User Manual
Page 11

DiabloSport Trinity Comprehensive User Manual Ver. 2.04
Page 11
Rev Limits‐ Gas vehicles only:
Increase or decrease the point your
vehicle
hits
a
rev
limit
in
gear
based
on
RPM.
This
setting
can
be
set
higher
or
lower
per
gear.
Speed Limits:
The Speed limiter Parameter will raise or remove the
speed limiter from the vehicle.
Shift Points RPM/MPH:
Allows users to set the shift points of their
vehicle
for
up
and
down
shifts
based
on
either
a
preset
mile
per
hour,
or
a
specific
RPM.
This
setting
may
vary
from
vehicle
to
vehicle.
Shift Pressure:
Over all shift pressure or line pressure adder. This
setting allows for firmer or softer shifts.
Tire Size:
This setting allows users to calibrate their speedometer for
non‐stock
or
oversized
tires.
Maximum
sized
are
up
to
55
inches
depending
on
application,
check
www.diablosport.com
for
information on your specific vehicle’s maximum tire size.
Boost Control (SRT4 Only)
Raise or lower the boost level in PSI based
on
percentage
of
total
boost.
2%
equals
around
1
PSI;
please
consult
a
tuning
professional
before
making
major
changes
to
this
setting.
2.4- Restoring the “Original Backup”
From time to time you may need to bring your vehicle in for service work
or emissions testing. With a performance tune installed on the vehicle,
the dealership’s diagnostic equipment may not connect or read your
PCM. To avoid this it is essential that you restore the “
Original Backup
”
to the vehicle before you bring it in for service or testing. Keep in mind
that only the “
Original Backup
” will restore the true factory settings to
your vehicle with no watermarks or footprints left in the PCM. Any tune
labeled “Factory HP Tune” or “Factory Tune” is not the same as your
“
Original Backup
”‐ it is actually a Diablo Tune File that lets you modify
the vehicle’s stock program without power gains. You may also want to
use your Trinity on another vehicle. The Trinity will not tune another
vehicle until the “
Original Backup
” has been restored and it is no longer
married/ VIN locked to a vehicle.
Let’s review how to restore your
vehicle’s “
Original Backup
”:
Step 1:
Plug
the
Trinity
in
to
your
vehicle's
OBD
II
port
and
press
the
“Performance”
menu
button
the
Trinity
Screen,
Agree
to
the
disclaimer,
then
scroll
down
on
the
Screen
until
you
see
“
Restore
Original Backup
” and select this option.
Step 2:
The
Trinity
will
ask
you
“Restore
original
backup
now?”‐
Press
“Yes"
to
restore
the
original
backup.
Step 3:
The Trinity will begin writing the original backup to your vehicle and
prompt
you
to
turn
the
key
on
and
off.
After
the
flash
process
is
complete,
reboot
the
Trinity
when
prompted.
Your
Trinity
will
now
be
unlocked
/
unmarried
from
your
vehicle
and
you
can
use
it
on
a
different
vehicle,
return
to
the
dealership
for
service
work,
or
bring
it
in
for
emissions
testing!