Ag Leader GPS 5200 User Guide User Manual
Page 49
GPS 5200 Receiver User Guide
43
Troubleshooting
5
Tracking but not receiving a
differential signal
The receiver is tracking satellites and
tracking an OmniSTAR satellite
beam, but is not receiving DGPS
signals. The Home screen indicates
how many satellites are being
tracked, and whether a differential
source is being tracked.
You see:
h-3D for HP not converged
H-3D for HP converged
r-3D for RTK float
R-3D for RTK fixed
D-3D for DGPS
HP and RTK also give an indication
of positional accuracy on the Home
screen (AgRemote).
Check that your DGPS service subscription is still
current and enabled.
For OmniSTAR service:
1. Use the AgRemote utility to navigate to one of
the following screens, depending on what you
are using:
•
the Omni HP Info screen
•
the Omni VBS Info screen.
2. Press
until Stop Date appears.
If the message
Access Unknown
appears, contact
OmniSTAR to reactivate your subscription. For more
information, see
.
The receiver must be switched on and configured to
track the correct satellite coverage beam before it
can be reactivated.
The receiver automatically tracks the correct beam
based on receiver geographic location. If the receiver
is manually changed, automatic tracking is
deactivated until you perform a hard reset or
firmware flash.
When a satellite subscription is activated, the Home
screen displays
D/3D
.
Problem
Possible solution
GPS5200_1A_UserGuide_ENG.book Page 43 Friday, December 19, 2008 12:57 PM