Ag Leader GPS 5200 User Guide - Manual (Page 35)

GPS 5200 Receiver User Guide 33
Configuring the Receiver 4
• OmniSTAR – paid subscription, available worldwide
You can use this paid service as an alternative to WAAS/EGNOS.
It provides over-the-air DGPS activation.
For more information, see Differential GPS positioning (DGPS), page 15 .
OmniSTAR
The GPS 5200 receiver can use OmniSTAR corrections. To do this, you
need to configure the receiver and purchase an OmniSTAR
subscription.
Note – To track the OmniSTAR satellite, the receiver must be outside with a
clear view of the sky, turned on, and configured to receive OmniSTAR VBS
or HP corrections.
To use the AgRemote utility to activate an OmniSTAR subscription:
1. Connect the GPS 5200 receiver to the computer. Turn on the
receiver and start the AgRemote utility. For instructions on how
to use AgRemote, refer to the AgRemote documentation.
2. In AgRemote, select Configuration / DGPS Config.
3. Set the Source Select field to one of the following:
– Omnistar HP
– Omnistar VBS
4. Set the EZ Sat: Omni* field to the area you are operating in. For
example, if you are working in California, select N. America West.
5. Press  then  to complete the procedure.
GPS5200_1A_UserGuide_ENG.book Page 33 Friday, December 19, 2008 12:57 PM