Ag Leader GPS 5200 User Guide - Manual (Page 32)

3 Installing the Receiver
30 GPS 5200 Receiver User Guide
Radar output
On the GPS 5200 receiver, Pin 7 on both Port A and Port B can be used
as Event Out, Alarm out, and Radar out. This pin can supply 5 V at
45 mA and sink up to 200 mA; the switching frequency of the circuit can
be up to 10 KHz.
The GPS 5200 receiver can output simulated radar pulses at a
pre-defined speed pulse output rate that is useful to replace the
radar/true ground speed sensor for speed on the vehicle or to send
speed to any other agricultural device that requires speed pulses, for
example, a yield monitor or variable rate controller.
Please contact your local reseller for cabling options.
GPS5200_1A_UserGuide_ENG.book Page 30 Friday, December 19, 2008 12:57 PM