Tso command support, 38 copying all datasets using dfsmsdss command – HP StorageWorks XP Remote Web Console Software User Manual
Page 88
88
ShadowImage for the XP128/XP1024/XP10000/XP12000
Example: DFSMSdss Commands
ShadowImage - FlashCopy can establish a relationship for one volume pair at a time. When
ShadowImage - FlashCopy copy is requested for a volume pair in the F-Copy status, DFSMSdss identifies
the request as an SI390 copy request through the host and performs SI390 copy operations.
The COPYVOID option is used to copy the volume serial number (VOLSER). If the COPYVOID option is
specified, the volume serial number is copied to the T-VOL and the T-VOL becomes offline automatically.
This COPYVOID option was necessary for SMS-managed volumes until the DUMPCONDITIONING
parameter was added to DFSMSdss with APAR OW 45674. If the DUMPCONDITIONING parameter is
specified, there is no need to copy the volume serial number for SMS-managed volumes.
When the DFSMSdss command is executed, all datasets on the source volume are copied to the T-VOL.
Volume area that is not allocated as a dataset is not copied.
Figure 38
Copying All Datasets Using DFSMSdss Command
NOTE:
You cannot specify both the COPYVOID option and DUMPCONDITIONING parameter at the
same time.
The following conditions cause the XP128/1024 to output the ADR935W message and end with CC = 4
(SI390 copy is performed through the host):
•
The size of the T-VOL is larger than the source volume within the same CU image.
•
The emulation types of the S-VOLs and T-VOLs are different within the same CU image.
NOTE:
When the SSID boundary is 64-LDEV and you establish a relationship between two
volumes that have the same CU image but different SSIDs, you can copy data from S-VOL to T-VOL
by the host program.
TSO Command Support
The following table lists and describes the TSO commands supported by ShadowImage - FlashCopy.
” on page 89 lists and describes the TSO command parameters
supported by ShadowImage - FlashCopy.
//COPYFULL JOB.....
//*
//INSTIMG EXEC PGM=ADRDSSU
//SYSPRINT DD SYSOUT=*
//SYSUDUMP DD SYSOUT=V,OUTLIM=3000
//SYSIN DD *
COPY FULL INDYNAM (SORCEV) OUTDYNAM (TRGVOL) COPYVOLID
/*