HP Photosmart 3110 All-in-One Printer User Manual
Page 44
Back view of the HP All-in-One
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One connected to the "1-LINE" port
3 Computer with modem
To set up your HP All-in-One with a computer modem
1.
Remove the white plug from the port labeled "2-EXT" on the back of your HP All-
in-One.
2.
Find the phone cord that connects from the back of your computer (your
computer modem) to a telephone wall jack. Disconnect the cord from the
telephone wall jack and plug it into the port labeled "2-EXT" on the back of your
HP All-in-One.
3.
Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.
Note
If you do not use the supplied cord to connect from the telephone
wall jack to your HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office. If the supplied phone cord is too
short, see
The phone cord that came with my HP All-in-One is not long
for information on extending it.
4.
If your computer modem software is set to receive faxes to your computer
automatically, turn off that setting.
Note
If you do not turn off the automatic fax reception setting in your
computer modem software, your HP All-in-One will not be able to receive
faxes.
5.
Set the
Auto Answer
setting to
On
.
For information on changing this setting, see
6.
(Optional) Change the
Rings to Answer
setting to the lowest setting (two rings).
For information on changing this setting, see
Set the number of rings before
.
7.
Run a fax test. For information, see
User Guide
41
Finish
setup