Case b: set up your hp all-in-one with dsl, Case b: set up your hp all-in-one with – HP Photosmart 3110 All-in-One Printer User Manual

Page 38

To set up your HP All-in-One with a separate fax line
1.

Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.

Note

If you do not use the supplied cord to connect from the telephone

wall jack to your HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office. If the supplied phone cord is too
short, see

The phone cord that came with my HP All-in-One is not long

enough

for information on extending it.

Set the

Auto Answer

setting to

For information on changing this setting, see

Set the answer mode

(Optional) Change the

Rings to Answer

setting to the lowest setting (two rings).

For information on changing this setting, see

Set the number of rings before

answering

Run a fax test. For information, see

Test your fax setup

When the phone rings, your HP All-in-One will answer automatically after the number
of rings you set in the

Rings to Answer

setting. Then it will begin emitting fax

reception tones to the sending fax machine and receive the fax.

Case B: Set up your HP All-in-One with DSL
If you have a DSL service through your telephone company, use the instructions in
this section to connect a DSL filter between the telephone wall jack and your HP All-in-
One. The DSL filter removes the digital signal that can interfere with your HP All-in-
One, so the HP All-in-One can communicate properly with the phone line. (DSL might
be called ADSL in your country/region.)

Note

If you have a DSL line and you do not connect the DSL filter, you will

not be able to send and receive faxes with your HP All-in-One.

User Guide

Finish

setup