HP Photosmart 3110 All-in-One Printer User Manual

Page 43

Back view of the HP All-in-One

1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One connected to the "1-LINE" port

To set up your HP All-in-One with voice mail
1.

Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.

Note

If you do not use the supplied cord to connect from the telephone

wall jack to your HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office. If the supplied phone cord is too
short, see

The phone cord that came with my HP All-in-One is not long

enough

for information on extending it.

Set the

Auto Answer

setting to

Off

For information on changing this setting, see

Set the answer mode

Run a fax test. For information, see

Test your fax setup

You must be available to respond in person to incoming fax calls, or your HP All-in-
One cannot receive faxes. For information on receiving faxes manually, see

Receive a

fax manually

Case G: Fax line shared with computer modem (no voice calls received)
If you have a fax line on which you receive no voice calls, and you also have a
computer modem connected on this line, set up your HP All-in-One as described in
this section.
Since your computer modem shares the phone line with your HP All-in-One, you will
not be able to use both your computer modem and your HP All-in-One
simultaneously. For example, you cannot use your HP All-in-One for faxing if you are
using your computer modem to send an e-mail or access the Internet.

Chapter 3

HP Photosmart 3100 All-in-One series

Finish

setup