HP ProLiant Support Pack User Manual
Page 76
Scripted deployment 76
Parameter
Description
Possible values
in a PSP, ISP, or bundle.
This parameter enables these components to
replace the older versions of the same
component that might have shipped with the
bundles.
SKIPTARGET
This parameter defines the behavior when a
remote target has an existing HP SUM session in
progress.
This parameter enables you to skip the host if an
existing HP SUM session already exists. A NO
overrides the session in progress and reinitializes
the installation framework on the remote host.
YES, NO
IGNOREERRORS
This parameter causes the installation to continue
and ignore errors.
The ServerNotFound option can be used to
bypass inactive or unavailable remote hosts
when deploying firmware or software to multiple
remote hosts at the same time.
FailedDependencies can be used to ignore any
failed dependencies and proceed with the ones
that are ready to be installed.
ServerNotFound,
BadPassword,
FailedDependencies
SOURCEPATH
This parameter can be used to provide a single
local repository path. This creates an inventory
from the given path instead of the local or
default repository.
Directory path
USELATEST
This parameter is a filter switch for use with
bundles. The parameter enables you to use the
latest version of the bundle when multiple
versions of bundles are listed on the command
line.
If no bundles are specified on the command line,
and multiple bundles are in the directory, then
this parameter enables HP SUM to use the
bundle with the latest version for installation.
YES, NO
DRYRUN
This parameter simulates the installation for a test
run. Nothing is installed.
YES, NO
OPTIONS
This parameter can be used to specify the HP
SUM CLI options inside the input file, which
overrides the configuration settings. Parameters
can be separated by a semi-colon, comma, or a
space.
One or more CLI switch
USESNMP
This parameter specifies that components, which
use SNMP protocol, are available to be selected
for installation.
These components are available for selection by
default. When the /usesnmp parameter is used,
and the /usewmi parameter is not used, the
WMI components are optional.
YES, NO
USEWMI
This parameter specifies that components, which
use WMI protocol, are available to be selected
YES, NO