HP StorageWorks XP Remote Web Console Software User Manual
Page 85
Table 50 Parameters for the FCESTABL Command (Version 2/Volume Copying) (continued)
Description
Value
Parameter
NO is the default setting.
Specifies the device number (device
address) of the T-VOL on which you
YES
TGTUCB
want to perform the FCESTABL
command. To specify this number, use
the TDEVN parameter.
YES is the default setting.
Specifies the serial number, the CU
number, and the LDEV number of the
NO
T-VOL on which you want to perform
the FCESTABL command. To specify
this number, use the TARGET parameter
instead of TDEVN.
Specifies the serial number, the CU
number, and the LDEV number of the
Serial number, CU number, LDEV
number of the T-VOL
TARGET
T-VOL on which you want to perform
the FCESTABL command.
Use this parameter when TGTUCB is
NO.
Uses the Remote FlashCopy function to
establish a relationship.
YES
REMOTE
Does not use the Remote FlashCopy
function.
NO
NO is the default setting.
Specifies the TrueCopy for Mainframe
source device number (device address).
TrueCopy for Mainframe source
device number
DEVIN
Use this parameter when REMOTE is
YES.
Specifies the serial number, the CU
number, and the LDEV number of the
Serial number, CU number, LDEV
number of the S-VOL
SOURCE
S-VOL on which you want to perform
the FCESTABL command.
Use this parameter when REMOTE is
YES.
Specifies the SSID of the CU on which
you establish the FlashCopy
relationship.
SSID
SSID
Use this parameter when REMOTE is
YES.
Suspends the write operations from the
host to all the S-VOL.
FREEZE
ACTION
Only the copied part from the S-VOL to
the T-VOL of the established relationship
FRR
will be copied. This command reverses
the S-VOL and the T-VOL of the
relationship. See
Establish the relationship without using
the Preserve Mirror FlashCopy function.
NO
PRESERVEMIRROR or PRESMIR
If PRESERVEMIRROR is not specified,
NO is set by default.
Establishing Version 2 Relationships
85