HP StorageWorks XP Remote Web Console Software - Manual (Page 108)

Table 58 Results from FCWITHDR Command (continued)
Results Parameter Setting
The command will do nothing and end
normally. Without any relevant relationships to
withdraw Unspecified
The FCWITHDR command will do
nothing and end normally. When the existing relationships do not
fall within the range specified by the
XTNTLST parameter Unspecified
There are several effective combination patterns of the parameters of the FCWITHDR command.
All combinations, other than those listed in
(page 108) will result in rejection of this command.
(page 108) describes the parameters of the FCWITHDR command and the applicable combinations.
Table 59 Combinations of Parameters for the FCWITHDR Command (Version 2)
Parameters Combination
ACTION XTNTLST DDSW DEVN TDEVN SDEVN
Target Source
Not specified Not
specified Not specified NO Not specified Specified Not specified (page 108)
Not specified Specified Specified NO Not specified Specified Not specified (page 109)
Not specified Not
specified Not specified NO Not specified Specified Specified (page 111)
Not specified Specified Specified NO Not specified Specified Specified (page 112)
Not specified Not
specified Not specified YES Not specified Specified or
not specified Specified (page 114)
Not specified Specified Specified YES Not specified Specified or
not specified Specified (page 116)
THAW Not
specified Not specified NO Specified Not
specified Not specified (page 117)
The information specified by the XTNTLST parameter is supported only when the following conditions
are fully met:
•
The information specified by the XTNTLST parameter must be for both the source and target.
If the information specified by the XTNTLST parameter is only for one of the two, the copy
operation will result in an error.
•
The size of the specified copy source and target extents must be the same.
•
The relationship must be established with INCREMENTAL = NO or must be established without
INCREMENTAL = NO or must be established without INCREMENTAL.
CAUTION: When the relationships are withdrawn by the FCWITHDR command executed with
the DDSW parameter set to NO or without setting the DDSW parameter, the data integrity of the
T-VOL cannot be guaranteed.
Case 1: TDEVN Specified, DDSW = NO
All the relationships established with the copy target extents existing in the device specified by
TDEVN are withdrawn. The relationships established with the copy source extents existing in the
specified volume are not withdrawn.
(page 109) an example of the command description for Case 1. This example requests the withdrawal
of all the relationships established with the copy target extents existing in the device numbered
4203.
108 Performing Version 2 Operations