HP Color LaserJet CP3520 Printer Series User Manual
Page 196
Control panel message
Description
Recommended action
UNSUPPORTED DRIVE INSTALLED
A non-supported hard drive has been
installed.
Turn off the product, remove the hard drive,
and then turn on the product.
USB ACCESSORY ERROR
This message appears when a connected
USB accessory draws too much power.
When this happens, the ACC port is disabled
and printing stops.
Printing can continue. The USB device
should be removed.
USB storage
One of the parameters of the USB storage
device is initializing.
No action is necessary.
USB STORAGE
working correctly.
1.
Turn product off.
2.
Disconnect the USB storage accessory,
and replace with a new USB storage
accessory.
USB STORAGE
A USB storage accessory has been
disconnected.
1.
Turn product off.
2.
Reconnect the USB storage accessory.
3.
Turn product on.
USB STORAGE DEVICE FAILURE
To clear press OK
The specified device has failed.
Press the
OK
button to clear.
USB STORAGE FILE OPERATION FAILED
To clear press OK
A PJL file system command attempted to
perform an illogical operation.
Press the
OK
button to clear.
USB STORAGE FILE SYSTEM IS FULL
To clear press OK
A PJL file system command could not store
something on the file system because the file
system was full.
Press the
OK
button to clear.
USB STORAGE IS WRITE PROTECTED
To clear press OK
The file system device is protected and no
new files can be written to it.
Press the
OK
button to clear.
USB STORAGE NOT INITIALIZED
This file-storage component must be
initialized before use.
Use the embedded Web server or HP Web
Jetadmin to initialize the component.
WAIT FOR PRINTER TO REINITIALIZE
This message can appear for a variety of
reasons: The RAM DISK settings changed
before the product has rebooted. The product
is restarting after changing external device
modes. The user has exited Diagnostics. A
new formatter has been installed with an old
engine or a new engine has been installed
with an old formatter.
No action is necessary.
WAITING FOR TRAY
The specified tray is lifting paper for feeding. No action is necessary.
WARMING UP
The product is coming out of Sleep mode.
No action is necessary.
WRONG CARTRIDGE IN
The indicated slot for a print cartridge
contains a cartridge that is not the correct
color. From left to right, the print cartridges
should be installed in this order:
●
Yellow
●
Magenta
Remove the print cartridge from that slot, and
install a cartridge that is the correct color.
Table 11-1
Control-panel messages (continued)
184 Chapter 11 Solve problems
ENWW