HP Color LaserJet CP3520 Printer Series - Manual (Page 195)

Control panel message Description Recommended action
SIZE MISMATCH IN TRAY XX The paper in the listed tray does not match
the size specified for that tray. 1. Load the correct paper.
2. Verify the paper is positioned correctly.
3. If the message persists, contact
HP Support at
www.hp.com/support/
cljcp3525 .
Sleep mode on The product is in sleep mode. A button press,
receipt of printable data, or an error condition
will clear this message. No action is necessary.
STANDARD TOP BIN FULL
Remove all paper from bin
The output bin is full. Empty the bin and continue printing.
TRAY [TYPE] [SIZE]
To change size or type press OK
To accept settings press
This message states the current type and
size configuration of the tray. To change size or type press the OK button.
To accept settings press the back arrow .
TRAY EMPTY [TYPE] [SIZE] The specified tray is empty and the current
job does not need this tray to print. Refill the tray at a convenient time.
TRAY OPEN The specified tray is open or not closed
completely. Close the tray.
TRAY OVERFILLED
Remove excess paper
The tray is filled above the stack-height
marking. Remove enough paper so that the paper
stack does not exceed the limit for the tray.
TRAY SIZE =
Media insert required in tray
The product is set to print on a small paper
size that requires the HP postcard media-
insert to be installed in this tray. To use this size paper, install the media insert
before loading the paper. See
Load trays
on page 83
TYPE MISMATCH IN TRAY X The specified tray contains a paper type that
does not match the configured type. The specified tray will not be used until this
condition is addressed. Printing can continue
from other trays.
1. Load the correct paper in the specified
tray.
2. Verify the type configuration.
UNABLE TO MOPY JOB The product does not have enough memory
to produce multiple original prints of this job.
One copy will be printed. Add more memory to the product. See Install
memory on page 149 .
UNABLE TO STORE JOB A job cannot be stored because of a memory
or configuration problem. Install additional memory in the product.
UNAUTHORIZED SUPPLY IN USE The product is using a non-HP supply. If you believe you purchased a genuine
HP supply, go to
www.hp.com/go/
anticounterfeit . Any product repair required
as a result of using non-HP or unauthorized
supplies is not covered under warranty. HP
cannot ensure the accuracy or the availability
of certain features.
Unsupported data on [FS] DIMM in slot x
To clear press OK
The data on the DIMM for the indicated file
system is not a type that the product supports.
[FS] can be either a ROM or Flash file system. Press the OK button to clear the message.
Replace the DIMM. See Install memory
on page 149 .
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 183