HP Color LaserJet CP3520 Printer Series User Manual
Page 192
Control panel message
Description
Recommended action
Remove all print cartridges
To exit press
The product is testing the transfer unit
assembly.
To perform the test, remove all the print
cartridges. To cancel the test, press the stop
button
.
Remove at least one print cartridge
To exit press
The product is testing the print-cartridge
motor.
To perform the test, remove at least one print
cartridge. To cancel the test, press the stop
button
.
REPLACE
The product indicates when a supply level is
at its estimated end of life. The actual life
remaining might be different than the
estimation. Have a replacement supply
available to install when print quality is no
longer acceptable. The supply does not need
to be replaced now unless the print quality is
no longer acceptable. After an HP supply has
reached its approximated end of life, HP’s
premium Protection Warranty on that supply
ends. You can configure the product to
continue printing by using the REPLACE
SUPPLIES menu. For more information
about the REPLACE SUPPLIES menu, see
.
Replace the specified color cartridge.
Change print cartridges on page 143
Or, configure the product to continue printing
by using the REPLACE SUPPLIES menu.
For more information about the REPLACE
SUPPLIES menu, see
REPLACE FUSER KIT
The fuser is nearing the end of its useful life.
Printing can continue.
CAUTION:
The fuser can be hot while the
product is in use. Wait for the fuser to cool
before handling it.
1.
Open the right door.
2.
Grasp the blue handles on both sides of
the fuser and pull straight out to remove
it.
3.
Install the new fuser.
4.
Close the right door.
REPLACE FUSER KIT
To continue press OK
The REPLACE SUPPLIES menu is set to the
STOP AT LOW setting. The fuser kit has
reached the low threshold.
CAUTION:
The fuser can be hot while the
product is in use. Wait for the fuser to cool
before handling it.
Press the
OK
button to continue printing until
the fuser reaches the end of life, or replace
the fuser now.
Replace the fuser
1.
Open the right door.
2.
Grasp the blue handles on each side of
the fuser, and pull it straight out to
remove it.
3.
Install the new fuser.
4.
Close the right door.
REPLACE SUPPLIES
For status press OK
Two or more supplies are at the estimated
end of life. The actual life remaining might be
different than the estimation. Have a
replacement supply available to install when
print quality is no longer acceptable. The
supply does not need to be replaced now
Press the
OK
button to see which supplies
need to be replaced.
Or, configure the product to continue printing
by using the REPLACE SUPPLIES menu.
For more information about the REPLACE
Table 11-1
Control-panel messages (continued)
180 Chapter 11 Solve problems
ENWW