HP Color LaserJet CP3520 Printer Series - Manual (Page 191)

Control panel message Description Recommended action
Printing The product is printing an internal page. The
product will return to the online Ready state
when the page is completed. No action is necessary.
PRINTING STOPPED
To continue press OK
Time has expired on the Print/Stop test. Press the OK button to continue.
Processing duplex job
Do not grab paper until job completes
Paper temporarily comes into the output bin
while printing a duplex job. Do not attempt to
remove the pages until the job is complete. Do not grab paper as it temporarily comes
into the output bin. The message will
disappear when the job is finished.
Processing... The product is currently processing a job but
is not yet picking pages. When paper motion
begins, this message will be replaced by a
message that indicates which tray the job is
being printed from. No action is necessary.
Processing...
CLEANING PAGE
The product is processing a cleaning page. No action is necessary.
Processing... copy of The product is currently processing or
printing collated copies. The message
indicates that copy X of Y total copies is
currently being processed. No action is necessary.
Processing... from tray The product is actively processing a job from
the designated tray. No action is necessary.
RAM DISK DEVICE FAILURE
To clear press OK
The specified device has failed. Press the OK button to clear.
RAM DISK FILE OPERATION FAILED
To clear press OK
A PJL file system command attempted to
perform an illogical operation. Press the OK button to clear.
RAM DISK FILE SYSTEM IS FULL
To clear press OK
A PJL file system command could not store
something on the file system because the file
system was full. Press the OK button to clear.
RAM DISK IS WRITE PROTECTED
To clear press OK
The file system device is protected and no
new files can be written to it. Press the OK button to clear.
RAM DISK NOT INITIALIZED This file-storage component must be
initialized before use. Use the embedded Web server or HP Web
Jetadmin to initialize the component.
Ready The product is online and ready for data. No
status or product attendance messages are
pending at the display. No action is necessary.
Ready
IP ADDRESS
The product is online and ready. No action is necessary.
Ready Diagnostics mode
To exit press
The product is in Diagnostics mode. To stop Diagnostic mode, press the Stop
button
.
Receiving Upgrade A firmware upgrade is in progress. Do not turn the product off until the product
returns to Ready.
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 179