HP Insight Management-Software - Manual (Page 93)

Figure 55 VC Domain Group LACP timer attributes
Adding or removing VC modules in a VC Domain Group
To add or remove VC modules to all VC Domains managed by a VC Domain Group:
1.
Click the VC Domain Groups tab.
2. Select the desired VC Domain Group where you want to add or remove VC modules, and
then click Delete.
For more information, see “Deleting a VC Domain Group” (page 84) .
3. For each VC Domain released from the VC Domain Group, insert or remove VC modules in
the corresponding enclosure, and perform the necessary domain, network, and storage
configuration changes in the VCM user interface.
Before VC module removal, remove the VC module uplink ports from all existing Network or
Shared Uplink settings from VC Domain configuration.
4. Return to VCEM, click the VC Domain Groups tab, and click New. For more information about
creating a VC Domain Group, see
“Creating a VC Domain Group” (page 41) . At step 1,
select the VC Domains to add to the new VC Domain Group. Wait until the job operation
completes. As a result, the new VC Domain Group created contains an updated configuration
reflecting the new VC modules.
NOTE: Existing server profiles cannot see new Fibre Channel SAN connections added using
these steps. However, if the fabrics were created on VCM, you can see the Fibre Channel SAN
connections. For more information, see
“Editing a server profile” (page 107) .
Adding or removing VC modules in a VC Domain Group 93