HP StorageWorks XP Remote Web Console Software - Manual (Page 174)

Name found on the EVA array. You can identify the EVA array's logical volume by this World Wide
LUN Name.
Figure 69 Configuration example for which logical volumes can only be identified by characteristic
.
Alternate path's behavior when an EVA array is connected
When an EVA array is connected, the alternate path's behavior differs depending on the EVA array's
microcode version.
If the array type is EVA3000/5000, the behavior of the alternate path differs between the EVA arrays
of the microcode version 4.000 or later and the EVA subsystems of the earlier microcode versions.
To replace the EVA array's microcode, check whether the alternate path's behavior changes as a
result of changing the microcode version. If the alternate path's behavior changes, perform XP External
Storage's Delete LU operation to release the setting for the EVA array volume's mapping before you
actually replace the microcode.
See the EVA array manuals for more information how the alternate path's behavior changes.
System parameter settings for connecting Sun StorEdge 6120/6320
When you connect a Sun StorEdge 6120/6320 as an external array, set the system parameters of
the Sun StorEdge 6120/6320 according to the following table. For the system parameters that are
not in the following table, see the manuals of the Sun StorEdge 6120/6320 and set the parameters
appropriately for the connecting configuration.
Table 26 System parameter settings for connecting Sun StorEdge 6120/6320
Parameter setting Parameter
SUN port host
System parameter settings for connecting Sun StorageTek FlexLine 380
When you connect a Sun StorageTek FlexLine 380 as an external array, set the system parameters
of the Sun StorageTek FlexLine 380 according to the following table. For the system parameters that
Notes on connecting external arrays 174