HP StorageWorks XP Remote Web Console Software - Manual (Page 159)

A Notes on connecting external arrays
Connecting Thunder 9500V subsystems
System parameters for connecting Thunder 9500V subsystems
Table 12 explains whether to specify system parameters when making settings for ports on the Thunder
9500V subsystem.
Table 12 System parameter settings (Thunder 9500V subsystems)
Parameter setting Parameter Pane name
Start Attribute
System Startup Settings
Specify this parameter when the Thunder 9500V subsystem
is in the one-controller configuration.
• Single Mode
Specify this parameter when the Thunder 9500V subsystem
is in the two-controller configuration.
NOTE:
Be sure to specify that Data Share Mode will be used.
• Dual Active Mode
Do not specify this parameter. • Hot Stand-By Mode
You can either specify this parameter or omit specifying
this parameter.
Delay Planned Shutdown Common 1
You can either specify this parameter or omit specifying
this parameter. SCSI Fibre Channel Com-
mon Options
OPTION 1
You can either specify this parameter or omit specifying
this parameter. SCSI Fibre Channel Com-
mon Options
OPTION 2
Set this parameter to Reset of occurred.
Operation if the processor
failure occurs
Data Striping
Set this parameter to ON.
Command Queuing
Mode
Inquiry Setting
Keep this parameter as HITACHI (default), and do not
change.
Vendor ID
Keep this parameter as DF600F (default), and do not
change.
Product ID
You can either specify this parameter or omit specifying
this parameter. ROM Microprogram Ver-
sion
XP External Storage Software User Guide 159