HP StorageWorks XP Remote Web Console Software - Manual (Page 164)

Parameter setting Parameters Pane
name
Specify this parameter to ON for AMS 1000, AMS 500, AMS
200, and WMS 100.
Specify this parameter to OFF for AMS 2500 and AMS 2300,
and AMS 2100.
Write and verify mode
You can either specify this parameter or omit specifying this
parameter.
Port Option
Port Op-
tions
Set this parameter to Standard Mode. Host Connection Mode 1
Host Con-
nection
Mode Do not specify any parameters.
NOTE:
As for AMS 1000, AMS 500, AMS 200, and WMS 100,
do not specify HISUP OFF mode either.
Host Connection Mode 2
NOTE:
You can either specify or omit any other parameters.
Relationship between serial numbers in device list on the LU operation panel
and TagmaStore AMS and TagmaStore WMS subsystem models
When the external array is a TagmaStore AMS or TagmaStore WMS subsystem, you can identify the
subsystem model from the serial number displayed in the Serial column in the Device list on the LU
Operation pane.
Table 17 shows the relationship between serial numbers displayed in the Serial column and subsystem
models.
Table 17 Relation between serial numbers and subsystem models (TagmaStore AMS and TagmaStore
WMS subsystems)
Model Displayed serial number Storage subsystem
AMS 2500 87XXXXXX
AMS AMS 2300 85XXXXXX
AMS 2100 83XXXXXX
WMS 100 71XXXXXX WMS
NOTE:
In serial numbers, X is an arbitrary number or character.
Notes on connecting external arrays 164