HP Modular Cooling System - Manual (Page 52)

Frequently asked questions 52
Frequently asked questions
Frequently asked questions
Question Answer
How many user sessions are
supported at one time? Only one user session is supported at a time. Sessions can be
terminated if a second session is initiated or if a console session
timeout occurs.
How many Admin sessions are
supported at one time? Only one Admin session is supported at a time. Sessions can be
terminated if a second session is initiated or if a console session
time-out occurs.
Why does my Admin session keep
getting disconnected?
If a second Admin session is initiated, the existing session is
terminated and the login screen appears.
Why can I not login using my FTP
user name and password? FTP Admin and Users are blocked until the Admin assigns
passwords and FTP is enabled in the Management menu of the
Remote Access tab.
How do I upgrade my firmware? For more information, see the Support Pack instructions included
with the firmware upgrade.
How do I change the management
module IP address? You can change the management module through the Network
menu (on page
32 ) or through the serial interface. For more
information on changing the management module IP address
through the serial interface, see the HP Modular Cooling System
User Guide on the documentation CD included with is kit.
Why do I get an extra line feed sent
from Windows® when I access the
serial interface connected through a
HP 16- and 48-Port Serial Console
Server?
You must assign this command to the HP 16- and 48-Port Serial
Console Server, where port X is the port where the MCS unit is
connected.
port x set out If=strip
port x set flow=Xonxof
Why are FTP admin and user logins
not recorded in the FTP.log? Only FTP file uploads are recorded in the FTP.log.
Can I assign the SSL default port 443
as a non-SSL port? Yes, you can configure any port, including port 443.
Why is the configuration file, when
restored, not appearing in the FTP
upload directory?
The configuration file is restored in another directory.
Why are active alarms appearing
after I power-cycle my management
module?
The alarms are updated every 30 minutes. If you power-cycle the
management module in-between this time frame, the alarms are still
active and appear. After power-cycling the first time, clear the
alarms, wait 30 minutes, and power-cycle again.
Why are my event.log and
alarm.logs not formatted correctly
when I download them in .bin mode?
The event.log and alarm.log are not formatted to be downloaded
in .bin mode. Use ASCII mode.