General menu – HP Modular Cooling System User Manual
Page 31
Web interface 31
General menu
Click General in the left navigation frame to display the General screen. This screen enables the Admin to
configure general management module parameters.
To change the general parameters:
1.
Enter a date in the Date field. (If NTP is enabled in the Network menu, do not enter a date in this
field.)
2.
Enter a time in the Time field. (If NTP is enabled in the Network menu, do not enter a date in this
field.)
3.
Select a date format from the Date Format dropdown box. Use MM/DD/YYYY for U.S. date format
and DD.MM.YYYY for Euro/World format.
4.
Select a temperature unit from the Temperature Units dropdown box.
5.
Select a measurement unit from the Measurement Units dropdown box.
6.
Select to enable or disable the audible alarm from the Audible Alarm (Beeper) radio buttons.
o
Select Enable to allow the audible alarm to sound when an alarm is generated.
o
Select Disable to not allow the audible alarm to sound when an alarm is generated.
7.
Select to enable or disable the reset alarm relay function in the Alarms/Warnings tab (on page
using the Alarm Relay Options radio buttons.
o
Select Enable to allow the alarm relay function when an alarm is generated.
o
Select Disable to not allow the alarm relay function when an alarm is generated.
8.
Select to close, open, or turn off the alarm relay options from the Alarm Relay Options radio buttons.
o
Select Close so that the alarm relay disconnects a circuit (normally closed) upon alarm activation.
o
Select Open so that the alarm relay completes a circuit (normally open) upon alarm activation.
o
Select Off so that the alarm relay is not activated (normally open) upon alarm activation.
9.
Enter a range for the web page automatic refresh interval in the Web Page Automatic Refresh
Interval field.
10.
Do one of the following:
o
Click Save Settings to save the information.