Network menu – HP Modular Cooling System User Manual
Page 32
Web interface 32
o
Click Clear Alarms to clear the alarms.
NOTE:
To clear the condensation pump cycles warning, click Cooling System in the left
navigation frame to access the Cooling System screen, and then click the Alarms/Warnings
tab. Under the Warnings section, set Alarm Reset to Manual and click Save Settings. Then,
return to the General menu and click Clear Alarms.
This step only clears the warning when the condensation pump is not running.
11.
Click Reset to Factory Defaults to reset the parameters to the defaults set by the factory. You are
prompted to reboot.
o
Click Restart to restart the management module.
o
Click Cancel to undo the changes.
Network menu
Click Network in the left navigation frame to access the Network screen. This screen enables the Admin to
configure network settings for the management module.
To set a static IP:
1.
Select Disable in the DHCP field. DHCP is enabled by default.
2.
Click Save Settings. A new screen appears telling you to restart your system.
3.
Click Yes and restart your system.