HP LaserJet 9000 Printer series - Manual (Page 213)

B Control panel menus 213
Configure device menu
or browsing the embedded Web server).
Item Options Values Explanation
TCP/IP ENABLE
CONFIG METHOD
MANUAL
SETTINGS
ON
OFF
BOOTP
DHCP
MANUAL
IP ADDRESS
n.n.n.n
SUBNET MASK
m.m.m.m
SYSLOG SERVER
n.n.n.n
DEFAULT
GATEWAY
n.n.n.n
IDLE TIMEOUT
xx
Selects whether the TCP/IP protocol is enabled ( ON ) or
disabled ( OFF ).
Selects whether the TCP/IP configuration parameters are set
automatically from a network server either using BootP
(Bootstrap Protocol), DHCP (Dynamic Host Configuration
Protocol), or manually from the EIO submenu.
Provides access to parameters that can manually configured
from the product control panel. For manual configuration,
CONFIG METHOD must be set to MANUAL .
The unique IP address of the product, where n is a value from
0 to 255.
The subnet mask for the product, where m is a value from 0 to
255. The mask is applied to IP addresses to uniquely identify
subnetworks and nodes.
The IP address of the syslog server used to receive and log
syslog messages.
The IP address of the gateway or router used for
communications with other networks.
The timeout value (in seconds) after an idle TCP print data
connection is automatically closed. The default value is 270
seconds. 0 disables the timeout.