HP LaserJet 9000 Printer series User Manual
Page 156
7 Problem solving
156
Correcting output quality problems
Job was not stapled.
Jobs sent to the stapler might not be stapled for one or more of the following reasons:
z
One-page jobs will not be stapled.
z
The stapler is out of staples and
AUTO CONTINUE
is set to
ON
.
z
The wrong size or type of paper was used for the job.
z
More than 50 pages were sent to the stapler, exceeding its capacity.
z
The stapler has bent or broken staples in the stapler head.
z
A staple jam was recently cleared (up to two sequential jobs might not be stapled).
z
The job was sent to a bin other than the stapler bin because the wrong size or type
of paper was used for the job.
z
The interface cable to the stapler unit might be defective or not connected
properly.
Job went to a different location
than was expected.
The wrong size or type of paper was used for the job. (See the introduce guide on the
product CD, or go to
.)
Last page did not print and the
Data light is on.
z
Make sure that you are using the correct driver.
z
Complex print job might still be processing.
z
Product might be waiting for the end of a file that did not come with the job. Touch
Continue to send it.
z
Make sure the product is not paused. Make sure the control panel reads
PROCESSING JOB
.
z
Pull out the print cartridge and check for paper. Reseat the print cartridge.
z
Open Trays 2 and 3. Make sure that the appropriate paper is loaded. (See the
introduce guide on the product CD, or go to
) Close
the trays.
Situation
Solution