HP LaserJet 9000 Printer series User Manual
Page 154
7 Problem solving
154
Correcting output quality problems
General operation problems.
For general paper operation information, see
General repeated stapler jam
problems.
z
Check to see that the job to be stapled is less than five mm (.08 inch) thick.
z
Stapler might have some trapped staple wires that are obstructing the magazine.
Remove loose staples and paper dust from the inside of the stapler (See
a staple jam from the stapler/stacker” on page 109
Job has been properly sent, but
the product will not print.
If the connection is broken before the entire print job has been transmitted to the
product (printing has not yet started), the product might not print any of the job. Press
S
TOP
to clear the product memory. Then, reposition the por table device within the
range of operation described in
“Printing a job using FIR” on page 80
, and print the
job again.
Job has incorrect fonts.
z
If you are printing an .EPS file, try downloading the fonts contained in the .EPS file
to the printer before printing. Use the HP LaserJet Utility (See
Macintosh computers” on page 19
z
If the document is not printing with New York, Geneva, or Monaco fonts, go into
the Page Setup dialog box, and select Options to deselect substituted fonts.
Job is not sent to the desired
printer.
Another printer with the same or similar name might have received the print job. Make
sure that the printer name matches the name selected in the Chooser (See
“Selecting an alternate PPD” on page 164
).
Situation
Solution