HP LaserJet 9000 Printer series - Manual (Page 206)

B Control panel menus 206
Configure device menu
PERSONALITY=AUTO AUTO
PCL
POSTSCRIPT Select the default product language (personality). Possible values are
determined by which valid languages are installed in the product.
Normally you should not change the product language (the default is
AUTO ). If you change it to a specific product language, the product does
not automatically switch from one language to another unless specific
software commands are sent to the product.
CLEARABLE WARNINGS=
JOB ON
JOB Set the amount of time that a clearable warning is displayed on the
product control panel.
ON : Warning messages display on the control panel until Continue is
touched.
JOB : Warning messages display on the control panel until the end of the
job from which they were generated.
AUTO CONTINUE=ON ON
OFF Determine how the product reacts to errors.
ON : If an error prevents printing, the message is displayed, and the
product goes offline for 10 seconds before returning online.
OFF : If an error prevents printing, the message remains on the display,
and the product does not print until Continue is touched.
Note
To stop printing when out of staples (when a stapler accessory is
installed), set
AUTO CONTINUE=OFF in the control panel System setup
menu.
Item Values Explanation