HP NonStop G-Series - Manual (Page 99)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6- 35
Command Execution Error Messages
Cause. An error occurred during an attempt to open a LOG TO command log file
file-name . A one-line textual description of the type of error encountered follows.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with the correct syntax.
Cause. A LOG TO command was specified while logging was already active.
file-name is the currently active log file.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Enter another command.
Cause. An error occurred during an attempt to close the currently active log file
file-name (as the result of a LOG STOP command). A one-line textual description of
the type of error encountered follows.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Enter another command.
Cause. A LOG STOP command was specified, but logging was not active when the
command was received.
Effect. SWCI waits for the next command.
Recovery. Enter another command.
Cause. An OBEY command was specified within the currently active command file
named
file-name , but nesting of OBEY commands is not allowed.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Remove the OBEY command from the command file.
***ERROR*** Log file file-name could not be opened.
***ERROR*** Log file file-name is already active.
***ERROR*** Log file file-name was not closed successfully.
***ERROR*** No log file currently active.
***ERROR*** Obey file file-name is already active.