HP NonStop G-Series - Manual (Page 67)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6 -3
Configuring the ATP6100 Line for SWCI
Communications
Configuring the ATP6100 Line for SWCI
Communications
The SWAN concentrator uses an asynchronous ATP6100 line to provide communication
between SWCI running on the primary and backup nodes and a switch module . If the
ATP6100 line is not already configured, perform the following steps at both the primary
node and backup node.
1. Use Compaq TSM to check the configuration of the EtherNet 4 ServerNet adapter
(E4SA) or Fast Ethernet ServerNet adapter (FESA) and the SWAN concentrator. If
TSM shows a configuration problem, refer to the following
•
For information about configuring an E4SA, refer to Ethernet Adapter (E4SA)
Hardware Installation and Support Guide and LAN Configuration and
Management Manual .
•
For information about configuring a SWAN concentrator, refer to the SWAN
Concentrator Installation and Support Guide, WAN Subsystem Configuration
and Management Manual, and WAN Wizard User’s Guide.
2. Create a PATPTERM profile.
The required values for the device and the interface type for the ATP6100 line are
included in the PATPTERM profile.
Parameter Variable Value Profile Modifier
Device
type 6 (terminal) DEVTYPE 6
subtype 0 (asynchronous
serial device) DEVSUBTYPE 0
Interface type RS-232-C EIA