HP NonStop G-Series - Manual (Page 83)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6- 19
STATUS Commands
•
To request only power supply voltage information about the switch module:
SWCI $NDSWA.#TERM>STATUS ENV, POWER
SCM Environment: Power
------
5.70 V
•
To request only temperature information about the switch module:
SWCI $NDSWA.#TERM>STATUS ENV, TEMP
SCM Environment: Temp 1 Temp 2
------ -------
35.7 C 35.9 C
•
To request only the position of the key switch on the SCC in the switch module:
SWCI $NDSWA.#TERM>STATUS ENV, KEYSWITCH
SCM Environment: Keyswitch
---------
REMOTE
Displaying Switch Card Status Information
The STATUS SC command displays information about the switch cards. The command
can return information about all switch cards or a single switch card in a specified slot.
The information includes the position of the switch, the lock status, the part number, and
the track ID for the switch card.
If a slot does not contain a switch card, the part number for the switch card is displayed
as EMPTY and all other attributes are blank.
STATUS SC { * | slot-num [ , sc-attr ] }
* Displays the status of all switch cards in the switch
module.
slot-num Displays the status of a switch card. slot-num is an
integer in the range of 1 through 8 (the slot number)
sc-attr Displays the status of a the specified attribute of a switch
card. sc-attr is one of the following:
POSITION Displays the position (straight or
crossed).
LOCK Displays the lock status (locked or
unlocked).
PARTNO Displays the part number.
TRACKID Displays the track identification number.