beautypg.com

Starting the nomadic disk manager – HP NonStop G-Series User Manual

Page 116

background image

Nomadic Disk Manager Interface

ServerNet Nomadic Disk User’s Guide425485-001

7 -2

Starting the Nomadic Disk Manager

Starting the Nomadic Disk Manager

For information on installation and configuration, see

Section 3, Installing and

Configuring the Nomadic Disk Manager

. The Nomadic Disk Manager is accessed by

entering the NOMADIC command.

IN infile

specifies the infile or process name for the Nomadic Disk Manager. If this parameter
is not specified, the Manager has the same infile that TACL process has when it
starts the Nomadic Disk Manager.

OUT outfile

specifies the file to which output is written. If this parameter is omitted, the
Nomadic Disk Manager writes to the output file of its parent TACL process.

command-string

is a string of Nomadic Disk Manager commands. If this parameter is included, the
command string is executed, and the Manager terminates. If this parameter is
omitted, commands are accepted from the input file. If multiple commands are
included in

command-string

, the commands must be separated by a semicolon.

Considerations

If the TMFCONFIG, TEMPLATE, or SQLNODE statement is found in the
configuration file, you will be prompted to remove these statements and restart the
Nomadic Disk Manager.

The ServerNet Nomadic Disk TACL procedures must reside in a TACL segment file
that is attached to the TACL process whenever the Super ID is used. Some functions
performed by the Nomadic Disk Manager require Super ID privilege.

The Nomadic Disk Manager accepts either a single command on a line or multiple
commands on a line. If you issue multiple commands on a single line, use
semicolons to separate the commands. If you enter multiple commands on the same
line, the Nomadic Disk Manager attempts to execute each command in the line,
regardless of the success or failure of any preceding command in the line.

If the Nomadic Disk Manager is being used interactively, you see a prompt of the
following form:

n ND>

The number n is the Nomadic Disk Manager prompt number, which is incremented
with each command entry. This number, like that of the TACL prompt, can be used
in the FC command.

NOMADIC [ / [ IN infile ] [ , OUT outfile ] / ]
[ command-string ]