HP NonStop G-Series - Manual (Page 71)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6 -7
Stopping SWCI
•
To start SWCI from a NonStop Himalaya S-series server other than the one
connected to the switch module, at a TACL prompt, type:
1>RUN $SYSTEM.SYSTEM.SWCI \node.$SwitchModuleDevice
where:
\node
is the name of the remote node that switch module is connected to.
$switchmoduledevice
is the device name of the switch module.
Stopping SWCI
To stop SWCI , use the SWCI EXIT command. For example:
SWCI $NDSWA.#TERM> EXIT