Nomadic disk manager commands, Summary of nomadic disk manager commands – HP NonStop G-Series User Manual

Page 117

Nomadic Disk Manager Interface

ServerNet Nomadic Disk User’s Guide—425485-001

7 -3

Nomadic Disk Manager Commands

•

Once you start the Nomadic Disk Manager, only valid Nomadic Disk Manager
commands are accepted until you exit the Manager, either inadvertently or by
entering EXIT or pressing Ctl-Y.

Nomadic Disk Manager Commands

The ServerNet Nomadic Disk Manager has its own set of commands. For examples on
using the Nomadic Disk Manager commands for both planned and unplanned outages,
see

Section 3, Installing and Configuring the Nomadic Disk Manager

and

Section 5,

Switchovers

Summary of Nomadic Disk Manager Commands

Note. In addition to this set of Nomadic Disk Manager commands, you can also use the TACL
HISTORY command and the full complement of TACL FC commands (FC, !, and ?, as defined
in the TACL Reference Manual). To allow the use of the TACL FC commands, the Nomadic
Disk Manager deletes the TACL history of commands before it starts processing its own
commands. However, the TACL history is preserved (in a ZZNDxxxx file). When you exit
Manager, either by error or by entering the EXIT or Ctl-Y command, the TACL history is
restored. The oldest command in the buffer is restored with a prompt number of one, and the
prompt number is incremented from there.

Command

Description

Page

ASSUME

Sets a default segment name

7-5

DOWN

Performs an SCF STOP DISK command on a set of objects

7-6

EXIT

Leaves the Nomadic Disk Manager and return to the TACL
process.

7-7