HP NonStop G-Series - Manual (Page 93)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6- 29
Command Input/Parsing Error Messages
Command Input/Parsing Error Messages
These messages indicate incorrectly specified SWCI commands or errors obtaining new
SWCI commands. If a command parsing error is detected, the corresponding error
message is displayed with a caret (^) character indicating the point in the SWCI
command at which the error was detected. Unless otherwise specified, these errors do
not cause SWCI to stop; however, a command parsing error stops execution of any
command file invoked by the OBEY command.
Cause. A SWITCH or STATUS command was received with a missing comma.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with the correct syntax.
Cause. A LOG TO command did not contain a log file name.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the LOG command with the correct syntax.
Cause. An OBEY command did not contain a command file name.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the OBEY command with the correct syntax.
Cause. An ALARM command was specified without ON or MUTE.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the ALARM command with the correct syntax.
***COMMAND ERROR*** Comma expected
***COMMAND ERROR*** Log file name expected
***COMMAND ERROR*** Obey file name expected
***COMMAND ERROR*** ON or MUTE expected