HP NonStop G-Series - Manual (Page 95)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk User’s Guide—425485-001
6- 31
Command Input/Parsing Error Messages
Cause. A LOCK, UNLOCK, or SWITCH command did not include a valid slot number
at the appropriate point in the command.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with the correct syntax.
Cause. A STATUS SC command contained an invalid slot-number value.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the STATUS SC command with the correct syntax.
Cause. A SWITCH command contained a comma but did not specify STRAIGHT or
CROSSED.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the SWITCH command with the correct syntax.
Cause. A LOG command was specified without TO or STOP.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the LOG command with the correct syntax.
Cause. Extra invalid parameters are detected at the end of an otherwise valid SWCI
command.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with correct syntax.
***COMMAND ERROR*** Slot number (1-8) expected
***COMMAND ERROR*** Slot number (1-8) or * expected
***COMMAND ERROR*** STRAIGHT or CROSSED expected
***COMMAND ERROR*** TO or STOP expected
***COMMAND ERROR*** Unexpected parameter