HP Integrity NonStop H-Series - Manual (Page 27)

<iTP Secure WebServer version> is the version procedure of the iTP Secure
WebServer release installed (for example, T8997H02_09FEB09_ADE_H028_01 ).
For example:
OSS> cd /usr/tandem/webserver/T8997H02_09FEB09_ADE_H028_01/bin
NOTE: You may have more than one version of iTP Secure WebServer available on
your NonStop system. Ensure that you select iTP WebServer version T8997H02 or later.
2. Verify the installation by checking the version of the httpd object using the VPROC
utility as follows:
OSS> vproc httpd
/usr/tandem/webserver/T8997H02_09FEB09_ADE_H028_01/bin
Binder timestamp: 25JAN2009 17:22:47
Version procedure: T8432H01_05MAY2006_CCPLMAIN
Version procedure: T8997H02_09FEB09_ADE_H028_01
TNS/E Native Mode: runnable file
The version of iTP Secure WebServer must be T8997H02 or later.
To install and set up iTP Secure WebServer on your NonStop system, see the iTP Secure
WebServer System Administrator's Guide.
• If you have iTP WebServer deployed on your NonStop system, you should know:
— Location of the iTP WebServer deployment directory. This directory will be referred to
as <iTP WebServer deployment directory> .
— IP Address and Port number on which your iTP WebServer is running.
If you do not have iTP WebServer deployed on your system, create your own iTP WebServer
deployment by following these instructions:
1. Go to the /usr/tandem/webserver/ directory on OSS, using the command:
OSS> cd /usr/tandem/webserver
2. Select the iTP WebServer version you want to deploy.
3. Go to the version-specific iTP WebServer installation directory on OSS, using the
command:
OSS> cd
where,
<iTP WebServer version> is the version-specific installation directory of iTP
WebServer you want to deploy.
For example:
OSS> cd T8996H02_09FEB09_ADE_H028_01
where,
T8996H02_09FEB09_ADE_H028_01 is the OSS directory where iTP WebServer is
installed.
4. Run the setup script to create your iTP WebServer deployment, using the command:
OSS> ./setup
where,
is the OSS directory where you want
to deploy your iTP WebServer instance.
For example:
OSS> ./setup/home/sash_usr/webserver
The setup script guides you through the deployment of iTP WebServer. For more
information on setup, see the iTP Secure WebServer System Administrator’s Guide.
Prerequisites 27